Sculpfun Rotary Switch Kit - All Metal Design - S6 S9 S30

Sculpfun Rotary Switch Kit, the easy way to swap between doing flat engraving/cutting and rotary work. No cable swapping, no wear and tear on connectors or cables. Instead, a simple switch which toggles between without all the fuss. Cables are plugged in and left plugged in, no need to connected or disconnect them unless you want to. And should you want to, the harness gives extra room to get your fingers on the cable connection.

Installation is a snap: one cable plugs swaps in for the Y stepper cable on the control board. The Y stepper cable plugs into the marked connector on the switch harness. Your rotary plugs into the remaining switch harness connector. To keep the switch easily accessible, use the included screws and T nuts (2020 and 2040 frames) or double sided adhesive tape (unibody frames) to attach the switch to your Sculpfun frame wherever it's out of the way but also easy to get at with your fingers. That's it, hardware install is done and the Sculpfun Rotary Switch is ready to use.

Leave your RA1 Pro connected all the time and flip the switch when you're ready to use it. Like all of our Sculpfun related products, checkout the dedicated product support page for more details. Installation time is estimated at about 5 minutes at the most.