U. S. Army Brass Engraving Plate For New Hermes Font Tray

U. S. ARMY MASTER ENGRAVING PLATE. SIZE IS 5" X 5" SQUARE. This is a large plate and will not slide into the copy tray. It is mounted to your copy stops using the included hardware package.

You unscrew your brass thumbscrews and then insert the stainless steel set screws. Leave them loose and then place the template over the set screws which will automatically set the spacing. Then lightly tighten the set screws with the hex wrench. Then just add the brass thumb nuts and tighten it. Please note that this will not work on the smaller GM model or the MINI-GRAV due to its size.


This will be attached to a piece of plywood and rolled in bubble wrap to protect it from damage. If you pay by noon I will mail the same day for faster service. Thank you for looking. PLEASE NOTE THAT THE HARDWARE KIT THAT IS SUPPLIED HAS FINE THREAD METRIC HARDWARE (5MM .8 PITCH). THIS FITS 99% OF THE MACHINES IN CIRCULATION.

HOWEVER THERE ARE A FEW MACHINES OUT THERE THAT USE A (SAE) #10-24 UNC AMERICAN PITCH THREAD ON THE COPY STOPS. IF THIS IS YOU PLEASE REQUEST THE 10-24 HARDWARE KIT WITH YOUR PLATE OR THE METRIC VERSION WILL BE INCLUDED BY DEFAULT.